Agilent Technologies 947 Betriebs- Und Servicehandbuch Seite 175

Models 947, 948 and 960 Leak Detectors Operations and Service Manual
ON
[SHIFT] A SEQ
OFF
2
FIL SEL
1
2
[SHIFT] FIL SEL
1
OUT V
SHOW
FIL #
OUT V
[SHIFT] SHOW
FIL #
RAW DTA
[SHIFT]
1
SET
REJ #
SHOW
SET
[SHIFT] REJ #
SHOW
SET
STD LK
SHOW
SET
[SHIFT] STD LK
SHOW
REJ3
SET
REJ 1
REJ3
[SHIFT] SET
REJ 1
REJ 4
SET
REJ 2
REJ 4
[SHIFT] SET
REJ 2
Turns on the Auto Sequencer function.
Selects filament #1 in the Ion Source.
Selects filament #2 in the Ion Source.
Displays the active filament number.
Displays the format of the analog leak rate output voltage.
Displays a set of readings from the leak rate A/D conversion.
Displays the active reject set point (1 through 4) and the value of
the reject set point.
Sets the active reject set point. Enter a number from 1 through 4,
then press the function key.
Displays the leak rate value to which the leak detector calibrates.
Sets the leak rate value to which the leak detector calibrates. Enter
X.XE-X (the desired value), followed by the SHIFT key, then the
function key.
Sets the leak rate value for Reject Set Point #1. Enter X.XE-X
(the desired value), then the function key.
Sets the leak rate value for Reject Set Point #3. Enter X.XE-X
(the desired value), followed by the SHIFT key, then the
function key.
Sets the leak rate value for Reject Set Point #2. Enter X.XE-X
(the desired value), followed by the SHIFT key, then the
function key.
Sets the leak rate value for Reject Set Point #4. Enter X.XE-X
(the desired value), followed by the SHIFT key, then the
function key.
A-7