End Of Operation - diversey Taski swingo 150B Handbuch

End of operation

• Press the switch cleaning solution.
The cleaning solution supply is
stopped.
• Allow the suction unit to run further so that the remaining
water in the hose will be sucked out.
• Switch off the suction unit.
The suction motor is switched off.
• Switch off the machine (main switch).
• Bring the machine to a parking and
transport position.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and remove the plug from the
mains socket.
Removing and cleaning the squeegee
• Open the cover of the brush housing
by loosening the side latches.
2
1
• Turn the four yellow clips to the left to
loosen the squeegees.
• Turn the machine onto the side to re-
move the squeegees.
• Wash out the squeegees under run-
ning water.
Notice:
Check the condition of the suction lips be-
fore the installation.
Bristles that are too short or damaged suc-
tion lips will impair the cleaning result!
• Reinstall the squeegees into the
squeegee body.
In doing this, note that the front and
rear squeegees are different. The po
sition is shown on the upper side of
the squeegees. (FRONT + REAR)
Empty and clean the recovery tank and fresh water tank
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment must be
observed.
Emptying the recovery tank and fresh water tank
• Remove the tank by pulling on the
1
tank unlocking device (1).
• Hold the tank (2) with the other hand
so that it does not fall out of the hold-
er when unlocked.
• Pull the solution tank out of the hold-
er.
2
• Empty the dirty water from the tank
through the opening provided at the
rear.
EN
-
61