Installation - ABB Orion2 Base Bedienungsanleitung

Installation

Warning! Make sure that the protection level assured by the AOPD is appropriate for the machine to be controlled,
see EN ISO 13849-1:2008

The outputs (OSSD) of the AOPD must be used as machine stopping devices and not as command devices.
The machine must have its own Start command.

The dimension of the smallest object to be detected must be larger than the resolution of the AOPD.

The AOPD must be installed in a room complying with the technical characteristics indicated in paragraph
"Technical data" of the instruction manual.Technical data

Do not place the AOPD near strong and/or flashing light sources or similar devices.

Strong electromagnetic interferences can jeopardize the function of the AOPD. Please contact your
ABB Jokab Safety representative for advice.

The operating distance of the device can be reduced in the presence of smog, fog or airborne dust.

A sudden change in environment temperature, with very low minimum peaks, can generate a small
condensation layer on the lenses and jeopardize the function.

Reflecting surfaces placed near the light beams of the AOPD (over, under or laterally) can cause passive
reflections. These reflections can compromise the recognition of an object inside the detection zone.

The safety device must be positioned at a distance that prevents a person or part of a person to reach the
hazard zone before the hazardous motion of the machine has been stopped by the AOPD. See the instruction
manual for the calculation of this minimum installation distance.
Warning! The minimum installation distance must be respected. For more information about its calculation,please
refer to the instruction manual or EN ISO 13855:2010.
Warning! Make sure to test the function and to perform the checks described in paragraph "Checks after first
installation" of the instruction manual before machine start-up.
2TLC172294M0201 Rev B
2015-09-17
3 www.abb.com/jokabsafety