Delivery Of The Coffee; Steam Dispensing - Faema E98/A-1 Compact Handbuch

English

Delivery of the coffee

Remove the filter holder, empty out any coffee grouts and fill it up
with 1 or 2 servings of ground coffee, depending on the filter holder
used.
Press the ground coffee down uniformly in the filter, using the grinder/
doser presser.
Remove any residues of ground coffee from the filter rim.
Fit and tighten the filter holder (7) on the coffee dispenser unit,
positioning the cup (or cups) under the nozzle (or nozzles) of the
filter holder (7).
Press the coffee dispensing push button (13, 14, 15 or 16) for the
required serving. The indicator light corresponding to the selected
push button will light up and dispensing will begin. The machine will
stop automatically.
Press the START-STOP push button (21) for continuous dispensing.
Dispensing, whether for dosed servings or in the continuous dis-
pensing mode, can be interrupted at any time by pressing the START-
STOP push button (21).
N.B. (for 1 dispenser unit machines only): during coffee dis-
pensing, the hot water (19) and cappuccino (10) dispensing
push buttons are not enabled.

Steam dispensing

1 Dispenser unit machines
Insert the steam jet pipe (5) in a suitable container and press the
steam dispensing push button (20).
When heating is completed, stop the outflow of steam by pressing
the steam dispensing push button (20) again or by pressing the
START-STOP push button (21).
N.B.: during steam dispensing, the hot water (19), milk (9)
and cappuccino (10) dispensing push buttons are not ena-
bled.
2 Dispenser unit machines
Insert the steam jet pipe (6) in a suitable container and turn the steam
setting knob (24).
When heating is completed, stop the outflow of steam by turning the
knob (24) in the opposite direction.
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.
Milk dispensing
MILK
Milk is a delicate biological product, and so it can easily spoil. Heat modifies
its structure. After opening the container and for all the time during which the
milk is being used, it should be kept at a suitable temperature to preserve it.
For this purpose, cold boxes are appropriate.
MILK DISPENSING
Plunge the small pipe (31) into the milk container.
After positioning the appropriate container under the cappuccino sys-
tem (2), dispensing can take place in two ways.
DOSED SERVING DISPENSING
Press the milk dispensing push button (9). The indicator light above the
selected push button lights up, dispensing starts and then stops auto-
matically when the serving has been dispensed. Dosed serving dis-
pensing can be interrupted at any time by pressing the START-STOP
push button (21).
CONTINUOUS DISPENSING
Press the milk dispensing push button (9) and keep it pressed until the
required amount of milk has been dispensed. Dispensing will stop
when the push button is released. In the continuous dispensing mode,
the programmed dosed serving remains unchanged.
For 2 dispenser unit machines, continuous dispensing is also possible
using knob (25).
N.B. (for 1 dispenser unit machines only): during milk dis-
pensing, the steam (20) and cappuccino (10) dispensing push
buttons are not enabled.
The Cappuccino System Use instruction chapter explains how
to obtain hotter or cooler and very frothy or not so frothy
milk.
13
14
7
20
1 gr.
6
9
2
31
1 gr.
English
16
15
21
24
2 gr.
6
9
25
2
31
2 gr.