Technical Data; Battery Charger; General Safety Advice For Electrical Power Tools; Workplace Safety - Parkside PAWP 18 A1 Originalbetriebsanleitung

Technical Data

Q
Cordless polishing machine
Rated voltage:
Idle speed:
Sound pressure level:
Buffing plate:
Rechargeable battery pack:
Rated voltage:
Capacity:
Energy content:

Battery charger:

Primary:
Rated voltage:
Rated power:
Secondary:
Rated voltage:
Charging current
Charging time:
Protection class:
Noise / vibration data:
Measured values for noise are determined in accord-
ance with En 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1,5 m / s
WARNING! The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in En 60745 and can be used to compare devices.
Different uses of the device give rise to different vibra-
tion levels and in many cases they may exceed the
values given in these instructions. It is easy to under-
estimate the vibration load if the electrical power
tool is used regularly in particular circumstances.
Introduction / General safety advice for electrical power tools
18 V
n = 3000 min
-1
0
60 dB (A)
ø 20 cm
18 V
1,5 Ah
27 Wh
230 V ~ 50 Hz
75 W
18 V
2600 mA
approx. 60 min
60 dB(A)
71 dB(A)
3 dB
= 2,6 m / s
2
2
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General safety advice for
electrical power tools
WARNING! Read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term "electrical tool" used in the safety advice
refers to electrical tools powered by mains electrici-
ty (by means of a mains lead) and electrical tools
powered by rechargeable batteries (without a
mains lead).

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
Do not work with the device
b)
in potentially explosive envi-
ronments in which there are
inflammable liquids, gases or dusts.
Electrical power tools create sparks, which can
ignite dusts or fumes.
c) Keep children and other
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.
GB/IE 7