Operation; Switching On/Off; Airflow Control; Work Breaks - Parkside PNTS 1500 D5 Originalbetriebsanleitung

GB MT
4. Installing the accessories:
- Push the vacuum hose (21)
into the suction connection
(10) until it locks in place.
To remove it, press the catch
(21a) and pull the vacuum
- Fit the handle with air control
(18).
- Install the telescopic suction
tube (19). (Press the button on
the telescopic suction pipe to-
wards
desired length).
- Install the nozzle desired
( 24-28).
Never vacuum without a filter!
Accessories such as the crevice noz-
zle ( 26), upholstery nozzle
( 27) or car nozzle (
be attached directly onto the han-
dle with air regulation (

Operation

Fully unwind the suction hose
( 21) before commencing work.

Switching on/off

Connect the mains plug.
To vacuum dust, plug the electrical
tool onto the mains socket on the
vacuum (
Only connect electrical appliances with a
maximum power rating of 2200 W.
Switching on the vacuum cleaner
(Permanent operation):
Move the On/Off switch (
position.
38
and pull out to the
28) can
18).
11).
13) to the "I"
Switch on electrical appliance +
vacuum cleaner:
1. Move the On/Off switch
13) to the position
(
2. Switch on electrical appliance.
Switching on the electrical appli-
ance automatically switches on the
vacuum cleaner. Once the electrical
appliance has been switched off,
the vacuum cleaner switches off fol-
lowing a time lapse.
Switching off the vacuum cleaner:
Move the On/Off switch (
"0" position.

Airflow Control

The airflow can be continuously adjusted
by turning the airflow controller (
minimum airflow
MIN:
maximum airflow
MAX:
When vacuuming with low-
powered electrical tools (such as
grinders or jigsaws), open the air
regulator on the handle (18). This
increases the suction power. To do
this, push the ring of the air regula-
tor upwards to three possible levels.

Work breaks

If you want to store away the assembled
suction equipment when you take a break,
you can
 push the telescopic suction tube (19)
together and insert the suction tube
holder (20) into the accessory holder
(3a) on the motor head (3);
the telescopic suction tube (19) can be
‚
placed in the retaining bracket (29).
13) to the
4).