Charging The Battery; Positioning The Solar Panel; Taking The Led Solar Spotlight Into; Operation - LIVARNO LUX 898-S Bedienungs- Und Sicherheitshinweise

Mounting the solar panel to a wall / roof
Attach the solar panel's bracket
panel / spotlight holder
sleeve , tightening it by hand (see figure A).
22
Use the mounting holes
„
wall bracket to mark the position of the drill
15
holes (see figure F).
Drill the holes (ø 6 mm)�
„
Now insert the wall plugs
„
holes (see figure F).
Lift the wall bracket
„
and attach it using the screws
Now push the holder of the solar panel /
„
spotlight onto the solar panel's wall bracket
3
until it very lightly snaps into place (see
15
figures A and F).
Connect the plug of the supply line
„
socket and then connect the plug of the
14
supply line with the charging socket
14
the LED Solar Spotlight (see figures A, C and D).
Align the LED Solar Spotlight as desired�
„
Please note: To dismount the holder, very
carefully press the tabs on the sides until the
holder is released�
Mounting the solar panel to the ground
spike
Attach the solar panel's bracket
„
connecting sleeve
22
figure A).
Now attach the LED Solar Spotlight
„
ground spike using the connecting sleeve
13
and push the spike into the desired substrate
22
(lawn, soil, etc.) (see figures A and D).
Please note: Make sure the solar panel is
attached firmly!
Now connect and fasten the supply lines
„
(see figures A and D).
14
Plug the supply line
„
(see figures C and D).
9
The spotlight and solar panel are now ready for
use�
RISK OF INJURY! Make sure to remove the
ground spike when removing the spot light to
to the solar
2
using the connecting
3
in the solar panel's
18
into the drilled
19
to the mounting position
15
(see figure F).
20
with its
4
9
to the
2
, tightening it by hand (see
to the
21
4
into the charging socket
14
avoid any risk of injury (e�g� tripping hazard)�
z Charging the battery
The battery is charged regardless of the position
„
of the switch� To optimise initial charging, charge
the LED Solar Spotlight while it is turned off�
Please note: The battery is fully charged
after it has been exposed to strong sunlight for
6 to 8 hours� The duration of the charging
process depends on the battery's charge level
and the quality of the sunlight�
z Positioning the solar panel
Cardinal point
The optimum alignment is south� A slight
deviation to the west should be chosen over a
deviation to the east�
of
Please note: To ensure perfect function, make
sure that the surface of the solar panel is clean�
Now align the solar panel and fasten it using
the bracket
z Taking the LED Solar
Spotlight into operation
Turn the ON / OFF / AUTO switch
„
(II) to permanently turn on the spotlight (see
figure C). The orientation light is deactivated in
this position (see figure C).
Turn the ON / OFF / AUTO switch
„
(0) to permanently turn off the spotlight (see
figure C).
Turn the ON / OFF / AUTO switch
„
"AUTO" (I) to activate AUTOMATIC mode� In this
and switch position, the spotlight will burn based on
the specified settings (burn time, ambient
brightness, detection range) (see figure C).
When the spotlight is turned off after the
„
specified burn time, the orientation light is
activated� The orientation light is only activated
in "AUTO" mode and deactivated if the switch is
in the "ON" position�
(see figure A).
2
to "ON"
8
to "OFF"
8
to
8
11
GB/CY