Care And Cleaning - Klarstein 10031955 Bedienungsanleitung

CARE AND CLEANING

Flushing the tubes
1 Turn off CO2 completely before attempting to clean. First, turn off the CO2 and
dispense beer until it stops. This will release pressure in the keg so that the coupler
can safely be detached.
2 Remove the hose from the coupler and carefully twist the dispenser faucet off of the
top of the product.
3 Ensure that the dispenser handle is in the down position before flushing the hose. If
this is not set correctly, water cannot flow through. Hold the open end of the hose
under running water for 3-5 minutes, while the beer dispenser faucet drains into the
sink. This will clear any excess beer that is trapped inside, helping to prevent any
bacteria or mold that could accumulate inside. Flush hose with water.
4 In order to clean and remove any excess beer that may leak into the unit space
inside the door, remove the black rubber insulation and wipe with a wet towel as
needed.
Detach
beer line
Flush hose
and coupler
with water
EN
29