Assembly - Klarstein 10031955 Bedienungsanleitung

ASSEMBLY

Read assembly instructions carefully to ensure that you understand all installation instructions
before installing the product. If after completing the process you are still unsure whether the
product has been properly installed, we recommend that you contact a qualified installer.
IMPORTANT: Allow the product to stand in an upright position for at least 8 hours
before plugging in the unit. This is very important! Once the unit is laid on its side, the
coolant in the refrigeration system is disrupted. The coolant in the refrigeration system
needs to stabilize before the unit is turned on.
Installing the Casters
1 Empty the inside of the cabinet completely
and lay the product down on its side. We
recommend that you place a piece of
cardboard or cloth underneath the cabinet to
prevent dents or scratches.
2 Place the washers over the caster bolts, and insert
the casters into the holes on the bottom comers of
the cabinet. Tighten each caster by turning the nut
clockwise with a wrench (not provided in the kit).
3 Once all four casters have been tightened,
stand the cabinet in its upright position.
NOTE: Two of the casters include locking mechanisms to ensure the unit does not slide
on hard floors. These two locking casters should be fastened at the bottom front of the
unit, with the plain casters fastened on the bottom rear.
Installing the Guardrail
1 Place the guardrail on the top of the
cabinet.
2 Align all support feet of the guardrail
with the holes on the top of the unit.
3 Press the support feet down firmly into
the holes to lock the gaurdrail in place.
Beer
Dispenser
Tower
Beer Duct
Guard Rail
Handle
EN
23