Klarstein 10031955 Bedienungsanleitung Seite 25

Some units may
come with this
attachment. It
is not needed
and should be
removed from
the coupler prior
to Step 3.
There are three different possible
backflow stoppers.
Step 6:
After the backflow stopper has been
inserted, there is a washer that should
be placed on top of the coupler.
Step 4:
Connect the CO2
line from the regulator to
the coupler
Step 7:
After the tap tower has been placed on
the refrigerator and the hose line feeds
through the bottom, attach the wing nut
to the coupler.
Step 3:
The CO2
rubber
directional
washer goes
into the
coupler.
Step 5:
Put one of
the backflow
stoppers in the
coupler (the
torpedo goes
in with rounded
side down).
OR
EN
25