Led Indicators; Cleaning And Care - GUTMANN ESTRELLA TYP EM 06 Bedienungsanleitung

Pressing the button again=Light
b
= Pressing the button 1x = fan ON,
Pressing the button 2x = Level 2,
Pressing the button 3x =Level 3,
Pressing the button 4x=intensive
a b c 1 2 3 4 f
Level
intensive level (motor switches back to level 3
after 5 minutes)

LED Indicators:

Information regarding the operating condi-
tions of the hood can be read on the de-
vice's LED indicators:
Cool Down
Level 1
Level 2
Level 3
Intensive Level
Filter Saturation Indicator
Filter Saturation : Button 1 (remote control
min. 15 sec. pressures to a
off (reset)The metal filter must be cleaned
regularly (at least every 14 days) to prevent
a fire hazard. The necessary cleaning of
the grease filter is also shown via the LED
indicator: the red LED on the ceiling unit
lights up as of 15 operating hours.
LED c: Indicates operational status:
LED c blinking: Indicates automatic cool
light (no LED).
OFF
Level 1, LED c + 1
ON
LED c + 1-2 ON
LED c + 1-3 ON
+
LED c + 1-4
ON
green LED
green LED
green LED
green LED
green LED
red LED
red LED goes
ON/OFF
down period (the hood will automatically
decrease by one power level every 5
minutes until it finally turns off)
LED 1: Power level 1 (lowest motor
speed), press button 2 on the remote
control once
LED 2: Power level 2 (middle motor
speed)
Press button 2 on the remote control
twice
LED 3: Power level 3 (high motor speed)
Press button 2 on the remote control
three times
LED 4: Intensive level (motor automati-
cally returns to level 3 after 5 minutes)
Press button 3 on the remote control
LED f: Filter Saturation Indicator
The metal filter must be cleaned when
the red LED lights up (see section on

cleaning and care).

Cleaning and care
Cleaning the surfaces
Danger due to electric shock! Discon-
nect the extractor hood from the power
supply by pulling the plug out of the
socket or by switching off the fuse.
When cleaning, make sure that no water
penetrates the device. Regular cleaning
of the surface saves laborious removal
of stubborn contamination. Only use
conventional detergents or universal
cleaning agents suitable for cleaning
stainless steel/aluminium. Never use
abrasive cleaning agents or steel wool.
After cleaning the hood, treat the stain-
less steel surfaces with a stainless steel
care product. Painted surfaces should
only be cleaned using a mild detergent
solution and a very soft cloth. Only use a
soft damp cloth to clean the operating
panel.
On hoods fitted with a panel below the
filter (edge extraction), grease deposits
occur at the edge of the panel. These
deposits occur for physical reasons and
are not due to a malfunction of the hood.
Please clean the panel underneath the
filter regularly to prevent the formation of
stubborn residues.
Cleaning and care instructions
When cleaning the grease filters, also
en
19