Filter Change; Metal Grease Filter - GUTMANN CRISTAL 9100EM Bedienungsanleitung

EN

Metal grease filter

Filter removal
Fire hazard ! Greasy residues impair the performance of the cooker hood and increase
the risk of fire. To prevent a fire hazard, the metal filter must be cleaned regularly. The
grease filters must be cleaned every 14 days at the latest. The necessary cleaning of
the grease filters is also indicated by the LED display: after 15 hours of operation, the
red LED on the ceiling unit starts flashing - please clean the metal filters afterwards.
Pull the glass flap down slightly with both hands until the magnetic contact is released.
Slowly swivel the glass flap down and the metal filters behind it can now be removed.
Metal filters are best cleaned in the dishwasher using a gentle dishwasher detergent.
The manufacturer does not assume any guarantee for possible discolorations caused
by the use of aggressive cleaning agents. Temperatures above 55 degrees should also
be avoided.
Attention: Do not use 3-phase cleaners or multi-phase cleaners. DO NOT clean the
metal filter in a commercial dishwasher. Cleaning with aggressive agents such as pet-
rol, acetone, trichloroethylene etc. will destroy the metal filters!
22

FILTER CHANGE

Please note: Due to a galvanic reaction
occurring during the rinsing process, the
metal grease filters must not be washed
simultaneously with silver cutlery or silver
dishes. There is no right to complaint if
this fact is not considered.
Reinsert
cleaning process, then keep the toggle
switch (F = filter saturation to the right)
pressed for 10 seconds. The operating
hours counter is reset and the red LED
goes out. Then lift the glass flap again
with both hands until it closes.
the metal filter after the