Msn - Transmit Phone Number - AUDIOLINE TERMINAL 2 Bedienungsanleitung

3. Press the OK button. The message "Pin Code >>" will appear in the display.
4. Now enter the five-digit PIN code using the keypad (factory setting 0 0 0 0 0) and confirm
the entry with OK. The message "MSN ?" will appear in the display.
5. Now press the
appears in the display.
6. Confirm with the OK button. The message " Ring For MSN 1?" will appear in the display.
7. Now select the MSN for which you want to change the ring tone using the
buttons.
8. Confirm with OK and the display will show "+ - Vol. *# - Pitch".
9. Now select the required volume between 00 (off) and 08 using the
choice can be made between 8 ring tones at the same time using the "
buttons.
10. Confirm your selection with the C button.
11. Now select the next MSN using the
12. Confirm with OK and the display will show "+ - Vol. *# - Pitch".
13. Now select the required volume between 00 (off) and 08 using the
choice can be made between 8 ring tones at the same time using the "
buttons.
14. Confirm your selection with the C button.
15. Now select the next MSN using the
16. Confirm with OK and the display will show "+ - Vol. *# - Pitch".
17. Now select the required volume between 00 (off) and 08 using the
choice can be made between 8 ring tones at the same time using the "
buttons.
18. Confirm your selection with the C and MENUE button.
Note: If the volume of an MSN is set to 0 (off), the symbol
3.11 MSN – Transmit phone number?
The ISDN telephone network provides the option of transmitting your own telephone number
to the person you are calling. If the phone of the person you are calling meets the technical
requirements, your phone number will be shown in the display. You yourself can decide
whether the phone number is transmitted or not.
1. Press the MENUE button.
2. Press the button as many times as necessary until the message "CID Send/Not Send
?" appears in the display.
3. Press the OK button. "CID Send ?" will appear in the display.
4. Now select whether you want to send the MSN phone numbers or not by using the
and buttons.
5. Then press the OK button to confirm the setting. If the phone number is transmitted, the
CID
symbol
6. Exit the programming mode by pressing the MENUE button.
- Setting up -
button as many times as necessary until the message "Audio ?"
will appear in the display.
or buttons and confirm with OK.
or buttons and confirm with OK.
MSN
or
or buttons. A
*
" and " # "
or buttons. A
*
" and " # "
or buttons. A
*
" and " # "
will appear in the display.
41