Charging Process - Parkside PHSSA 20-Li A1 Originalbetriebsanleitung

GB MT
to ensure that they do not play
with the equipment.
• To charge the battery, use only
the charger supplied.
Risk of fire and explosion. This
ensures that the safety of the de-
vice is maintained.
• Before each use, check the charg-
er, cable and plug and have them
repaired by qualified profession-
als and only with original parts.
Do not use a defective charger
and do not open it up yourself.
This ensures that the safety of the
device is maintained.
• Connect the charger only to a
socket with an earth. Ensure that
the mains voltage matches the
specifications on the charger rat-
ing plate. Risk of electric shock.
• Disconnect the charger from the
mains before closing or open-
ing connection to the battery/
power tool/device.
• Keep the charger clean and
away from wet and rain. Do not
use the charger outdoors. Dirt
and the entry of water increase
the risk of electric shock.
• Operate the charger only with
the appropriate original batter-
ies. Charging other batteries may
result in injuries and risk of fire.
• Avoid mechanical damage to
the charger. This can result in
internal short circuits.
• Do not operate the charger on a
combustible surface (e.g. paper,
textiles). Risk of fire due to heat-
ing during charging.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
28
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not use the charger to charge
non-rechargeable batteries. The
device could become damaged.

Charging Process

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charger,
check that the battery's outer
surface is clean and dry.
There is a risk of injury due
to electric shock.
Switch off the device and remove
the battery before carrying out any
maintenance work.
• Charge the battery before the first time
of use.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an original replace-
ment battery from the Parkside X 20 V
Team series, which can be purchased
from customer service.
• Always take heed of the applicable safety
instructions as well as the environmental
protection regulations and information.
• The warranty excludes all defects
caused by improper handling.