Inhaltsverzeichnis
Werbung
3
Rotate the MENU SEL knob/ENTER button to align the
arrow marker (
) to the item to be set and push on
,
the MENU SEL knob/ENTER button.
To use the level indicator
Setting INDICATOR to ON displays the level indicator on
the viewfinder.
You can set the display format with the menu items below.
MODE: Set the type and position of the indicator.
LEVEL: Set the density and the response speed of the
indicator.
GAIN: Set the sensitivity of the indicator.
OFFSET: Set the offset of the focus detection value.
1)
Normally, the sensitivity of the indicator is automatically set to
the optimum value in conjunction with the AREA MARKER
SIZE set value. Use this setting when an optimum sensitivity
value cannot be obtained, depending on the shooting
environment.
2)
Normally, the optimum offset is automatically set in conjunction
with the AREA MARKER SIZE and MASTER GAIN set values.
Use this setting when the optimum offset cannot be obtained,
depending on the shooting environment.
To use the area marker
Setting AREA MARKER to ON displays the detection area
of the focus as a marker on the viewfinder screen.
You can set the size and position of the detection area
with the menu items below.
SIZE: The size of the detection area can be changed. (If
the area size is too large, both the subject and the
background are included in the area, making the
indicator display may easily deviate from the
subject.)
POSITION: Roughly set the position of the detection area.
POSITION H: Finely adjust the position of the detection
area in the horizontal directions.
POSITION V: Finely adjust the position of the detection
area in the vertical directions.
4
Rotate the MENU SEL knob/ENTER button to display
the desired setting and push on the MENU SEL knob/
ENTER button.
5
To finish the adjustment, set the DISPLAY switch to
OFF to exit Menu mode.
Notes
• The level indicator and the effect area marker cannot be
displayed simultaneously, whichever you set to ON later is
preferentially displayed.
• The area marker and the aspect safety marker cannot be
displayed simultaneously, whichever you set to ON later is
preferentially displayed.
• When displaying the focus assist indicators, check that the
flange focal length has been precisely adjusted.
See "Adjusting the Flange Focal Length" on page 15 for the
flange focal length.
24
Setting the Camera Outputs
Setting the Camera
Outputs
You can specify video signals directly output from the camera,
with menu operations.
Note
1)
The MAIN (camera picture), RET (return video), or VF (the
2)
same picture as that displayed on the viewfinder screen)
setting is common to SD-SDI and VBS. Different signals
cannot be output.
The menu pages used for the output settings have been
registered to the USER menu at the factory.
• <OUTPUT FORMAT>
• <TEST OUT>
• <SDI OUT>
Set the following menu items to the settings shown in the
table.
For details on menu operations and the USER menu, see
"Menu Operations" on page 27.
Outputting the signal being shot (camera
picture)
The same textual information as that displayed on the
viewfinder screen can be added to the output signal by setting
CHARACTER to "ON" on the <SDI OUT> or <TEST OUT>
page.
To output as HD-SDI
Menu page
<SDI OUT>
To output as SD-SDI
Menu page
<SDI OUT>
To output as VBS
Menu page
<TEST OUT>
Item
Setting
SDI-MONI OUT
MAIN
Item
Setting
SDI-MONI OUT
SD-SDI
DOWN CONVERTER
MAIN
SELECT
Item
Setting
OUTPUT
VBS
DOWN CONVERTER
MAIN
SELECT
Werbung
Inhaltsverzeichnis
