Inhaltsverzeichnis
Werbung
To select the ND filter
Press the ND filter select button while holding the FILTER
LOCAL button depressed.
Each press of the select button switches the available ND
filters (clear, 1/4ND, 1/8ND, 1/16ND,1/64ND) in
sequence.
To select the CC filter
Press the CC filter select button while holding the FILTER
LOCAL button depressed.
Each press of the select button switches the available CC
filters (cross, 3200K, 4300K, 6300K, 8000K) in sequence.
H D
MU LT I FO RM
AT SE RI ES
ND filter select button
FILTER LOCAL button
ND filter
1
clear
2
1/4 ND
3
1/8 ND
4
1/16 ND
5
1/64 ND
3
Place a white pattern in the same lighting conditions
as the subject, and zoom in on it so that a white area
is obtained in the screen to satisfy the positional and
quantitative requirements illustrated below.
A white object (white cloth, a white wall, etc.) near the
subject may be used in place of a white pattern.
A rectangle centered in the screen. The length of the sides
must be at least 70% of the height and width of the screen.
Within this rectangle, there must be an area of white greater
than 10% of the entire screen.
CC filter select button
Color temperature
conversion filter
A
cross filter
B
3200K (clear)
C
4300K
D
6300K
E
8000K
Note
Be careful not to have any spots of high illumination in the
rectangle.
4
Adjust the lens iris opening.
With a manually adjusted lens: Set the opening to an
appropriate value.
With a lens which has automatic iris control: Set the
lens' automatic/manual iris control switch to
automatic.
5
Push the AUTO W/B BAL switch to WHT and release
the switch.
AUTO W/B BAL switch
The switch will return to the center position, and adjustment
will be performed.
During adjustment, the message "AWB: EXECUTING" will be
displayed on the viewfinder screen.
After about one second, a message like the one in the figure
below will be displayed, and the adjustment process will
complete. The adjusted value will be automatically stored in
the memory (A or B) selected in step 1.
AWB:OK
Note
When using a zoom lens with automatic iris control capability,
1)
hunting
may occur. Adjust the lens' iris gain control (labeled
IG, IS, S, etc.).
1)
Hunting: The automatic iris responds over and over, and the image
repeatedly darkens and lightens.
For more information, refer to the lens' operation manual.
When automatic white balance adjustment fails
If the white balance adjustment process does not end
successfully, the error message "AWB: NG" will be displayed
on the viewfinder screen for approximately three seconds.
If this error message is displayed, try white balance
adjustment again.
If the error message continues to be displayed after several
attempts, the camera requires internal inspection.
Adjustments and Settings for Shooting
21
Werbung
Inhaltsverzeichnis
