Inhaltsverzeichnis
Werbung
Front left
1
2
3
4
a NETWORK TRUNK connector (RJ-45 8-pin)
Connects a device connected to the CCU's NETWORK
TRUNK connector to the network.
Caution
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this port.
Follow the instructions for this port.
• When you connect the LAN cable of the unit to peripheral
device, use a shielded-type cable to prevent malfunction
due to radiation noise.
ATTENTION
Par mesure de sécurité, ne raccordez pas le connecteur pour
le câblage de périphériques pouvant avoir une tension
excessive à ce port. Suivez les instructions pour ce port.
VORSICHT
Aus Sicherheitsgründen nicht mit einem Peripheriegerät-
Anschluss verbinden, der zu starke Spannung für diese
Buchse haben könnte. Folgen Sie den Anweisungen für diese
Buchse.
b RET 1 (return video 1) button
The return video 1 signal from the camera control unit is
monitored on the viewfinder screen while this button is
pressed. It function the same as the RET 1 buttons on the
handle (page 10) and that on the operation panel on the rear
of the camera (page 13).
You can also assign other functions to this button, using the
menu displayed on the viewfinder screen.
c MIC 1 IN (microphone 1 input) connector (XLR 3-pin)
Connect a microphone.
This connector and the AUDIO IN CH-1 connector (page 14)
on the operation panel on the rear of the camera are
alternately activated with the CH1 audio input select switch
(page 14).
d MIC (microphone) power switch
+48V: To supply a power of +48 V to the connected
microphone.
OFF: Not to supply a power to the connected microphone.
e SHUTTER switch
For setting the electronic shutter functions when the camera is
used in standalone status without connecting a camera control
unit.
OFF: The electronic shutter does not function.
ON: The electronic shutter is activated.
SEL: The shutter speed and shutter mode change each time
For details, see "Setting the Electronic Shutter" on page 22.
H D
SER IES
MUL TI FOR MAT
f INTERCOM LEVEL control
To adjust the intercom/earphone volume level.
The intercom level adjustment is enabled when the
INTERCOM 1 and 2 LEVEL/MIC switches (page 12) on the
rear of the camera are set to "FRONT."
5
g RET 2 (return video 2) button
6
When this button is pressed, the picture on the viewfinder
screen changes to the return video signal selected with the
7
RET 2 select switch (page 13) on the operation panel on the
rear of the camera.
You can also assign other functions to this button, using the
menu displayed on the viewfinder screen.
Rear
a DC power supply out connector (2-pin)
Supplies power to an external device up to 2.5 A.
b CAMERA POWER switch
CCU: Power is supplied from the camera control unit.
EXT: Power is supplied through the DC IN connector.
c Tally lamp and switch
ON: The tally lamp lights when a tally signal is input to the
OFF: The tally lamp is prevented from lighting.
the switch is set to this position.
1
2
connected camera control unit or a call signal is
generated in response to pressing of a CALL button.
Locations and Functions of Parts
3
Shoulder strap fitting
post (page 9)
Operation panel
(page 12)
4
5
6
7
Connector panel
(page 13)
8
11
Werbung
Inhaltsverzeichnis
