Panasonic EY7441 Bedienungsanleitung Seite 13

NOTE:
When selecting AUTO on the
EY7443
During AUTO mode operation, the tool
may switch to LOW speed under light
loads if there is little remaining battery life
or if the battery pack temperature is low
(0°C or less). In this case, charge the
battery pack or place the battery pack in a
warm location for at least one hour to
allow it to warm up before use.
Depending on the load, the tool may
switch back and forth between HIGH and
LOW speed operation multiple times. If
this switching is undesirable, set the tool
to HIGH or LOW speed manually.
CAUTION:
• Check the speed selector switch
before use.
• Use in low gear when high torque is
required in operation. (Using in high
gear with high load can cause motor
overload and possible failure.)
• To prevent excessive temperature
increase of the tool surface, do not
operate the tool continuously using
two or more battery packs. The tool
needs cool-off time before switching
to another pack.
• Ensure that air vents on the sides of
the main unit are not blocked during
operation. Covering them can cause
the tool to overheat and motor
damage to occur.
• Do NOT strain the tool (motor). This
may cause damage to the tool.
• Avoid contact with air from vent holes
during operation as under heavy load
this can become hot and potentially
cause injury.
Bit-locking Function [Fig.9]
1. With the trigger switch not depressed
and a screwdriver bit locked in place,
the tool can be used as a manual
screwdriver (up to 22.6 N•m,
230 kgf•cm, 199 in•lbs).
There will be a little play in the chuck,
but this is not a malfunction.
EY971074418.indb 13
2. This feature is handy for tightening
screws that require more torque than
the maximum torque of the driver
(position
the tightness of a screw or to loosen an
extremely tight screw.
Changing the Belt Hook Location
Side [Fig.10]
The belt hook can be attached to either
side of the unit.
1. Removing the hook
(1) Remove the nut.
(2) Draw out the hook.
2. Attaching the hook to the other side
(1) Insert the hook in the other side.
(2) Tighten the nut fully so that it
securely fastened.
WARNING!
• Be sure to attach the belt hook securely
fastened. When the belt hook is not
hook may disconnect and the tool may
fall. This may result in an accident or
injury.
• Periodically check screw for tightness.
•
and securely onto a waist belt or other
belt. Pay attention that the tool does
not slip off the belt. This may result in
an accident or injury.
• When the tool is held by the belt hook,
avoid jumping or running with it. Doing
so may cause the hook to slip and the
tool may fall. This may result in an
accident or injury.
• When the tool is hooked onto the waist
belt by the belt hook, do not attach
driver bits to the tool. A sharp edge
object, such as a drill bit, may cause
injury or an accident.
- 13 -
EN
2018-05-28 10:27:02