SOLIS BARISTA PERFETTA PLUS Bedienungsanleitung Seite 65

Programming the appliance for use without water filter:
The default setting is that no water filter is inserted. However, we recommend
●
inserting the included BRITA INTENZA water filter cartridge in any case and per-
forming the previously specified programming.
If for some reason you do not want to insert a water filter, you can leave the
●
default setting. If you have stopped using a water filter, proceed as described on
page 127, but push the
to confirm the programming. The Prog. button flashes twice, the setting is saved
and completed and a signal sounds twice. The "no water filter" programming
GB
disables the water filter replacement alarm and decreases the descaling interval
time.
ATTENTION: Do not run the machine without BRITA INTENZA water filter cartridge
with setting 'yes'. Any damage caused by limescale will not be covered by warranty.
In general:
Pushing the Prog. button gets you to programming mode.
Subsequently pushing the button gets you to the water filter settings menu.
After that, you can perform the following settings:
is the setting for "with water filter"
is the setting for "no water filter"
ATTENTION:
If the button alternately flashes white and red and simultaneously the
constantly lights up white, the water filter replacement alarm has been triggered!
In this case, empty out the water tank, replace the old water filter cartridge with a
new one and proceed as described on page 141!
128
button in the 4. step. Then, press the Prog. button
2. Setting the brewing temperature
You can set a low, medium or high brewing temperature.
The default setting is medium. You can reduce or increase this standard temperature.
In operation mode, push the Prog. button to switch to pro-
●
gramming mode. The Prog. button flashes quickly, a signal
sounds and the other three buttons flash alternately.
Push the
●
ing temperature with the button illumination.
Now, set the desired brewing temperature:
●
Push the
Standard temperature setting
Push the
Low temperature setting
button
Push the
High temperature setting
Push the Prog. button again to save the setting. The Prog.
●
button flashes twice and a signal sounds twice.
After that, the appliance returns to operation mode.
●
In general:
Pushing the Prog. button gets you to programming mode.
Subsequently pushing the
menu.
After that, you can perform the following settings:
is the setting for "low temperature"
is the setting for "medium temperature" (default setting)
is the setting for "high temperature"
Push the Prog. button to save the program.
. button. The machine indicates the current brew-
button:
button:
button:
button gets you to the brewing temperature settings
GB
129