Auping AVS Superbox Gebrauchsanweisung Seite 23

The box spring fails to
respond to the infrared
remote control
Infrared remote
control, lights blinking
The box spring fails to
respond to the remote
control with cable
Hinge defect
_01J8C_4267 - BW.pdf - pag.21
Cause Search
The signal from the Check if the system
works by pointing the
handset is not being
handset directly at the
picked up by the
control unit beneath the
receiver in the control
bed. Check if the control
unit. The signal may fail
unit has been fixed
to reach the receiver if
properly.
the handset is a
substantial distance
from the control unit or
the latter is covered by
a duvet, for example.
Processor failure.
Ruptured wire in cable. Check cable at strain
relieve.
Transport failure.
LET OP !!! Lage resolutie!
Solution
Remove the duvet or
blankets that may be
interrupting the signal.
Install IR preamplifier if
necessary.
Reset. Take batteries
out, push some buttons.
Put batteries in again.
Replace.
Replace upper frame.
GB21
July 28, 2009