Auping AVS Superbox Gebrauchsanweisung Seite 21

Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Sparks fly when the
box spring control
system is being
plugged into the
transformer
Motor runs for a while
then stops
Strange occurrences.
Motor does not adjust,
or only partially, etc.
Wrong motor engages
Nothing works
_01J8C_4267 - BW.pdf - pag.19
Cause Search
Caused by moving parts
touching each other.
The box spring is not
leveled because the
floor is not absolutely
flat.
The reason for this may
be a missing part, or
parts that have not been
tightened properly or
have become loose
when the bed was
moved.
The bed is not
positioned away from
the wall.
There are unwanted
objects in the bed that
should not be there
(spoons, forks, pens,
etc.).
The plug is already in
the wall socket before
the box spring control
system is connected.
Faulty Hall sensor in
motor.
Processor malfunction.
Wrongly installed.
The plug is not in the
socket.
LET OP !!! Lage resolutie!
Solution
Apply Teflon spray.
Do not use oil.
Make sure the floor is
absolutely leveled.
Tighten parts.
Position the bed away
from the wall.
Remove those objects.
First connect the box
spring control system,
then put the plug into
the socket.
Set bed in horizontal
mode by alternately
adjusting up and down a
little at a time. Replace
motor.
Reset. Unplug the bed,
wait a short while then
plug back in.
Install according to
fitting chart.
Put the plug into the
socket.
GB19
July 28, 2009