Continuity Test - HT HT7 Bedienungsanleitung

5.6.

CONTINUITY TEST

Before taking the continuity test, disconnect the circuit under test from any
power source and discharge all capacitors.
1. Perform the preliminary Autotest (see § 4.3).
2. Connect the L1 and L2 probes to the object under test (see Fig. 7)
3. Continuity test is active for resistance
along with LED
bargraph values are not significant in this test and do not indicate the resistance
value of the object under test.
4. The instrument automatically turns off when the probes are separated from the object
under test or the applied voltage is lower than 3V DC.
5. Press the key to switch on the white LED illuminator to perform measurements in
dark environments.
Fig. 7: Continuity test
<200k. The instrument turns automatically on
and the buzzer indicating a positive test. The display and
EN - 11
CAUTION
HT7