General Power Tool Safety Warnings; Work Area Safety - Parkside PSBM 1100 A1 Originalbetriebsanleitung

Noise emission value:
Noise measurement value determined in accor-
dance with EN 60745 . The A-rated noise level of
the power tool is typically as follows:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Wear hearing protection!
Total vibration value:
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 60745:
Drilling into metal:
(Main handle) a = 4,8 m/s
h,D
(Auxiliary handle) a
h,D
Impact drilling into concrete:
(Main handle) a = 9,3 m/s
h,ID
(Auxiliary handle) a
h,ID
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons . The
specified vibration emission value can also
be used to make an initial exposure estimate .
PSBM 1100 A1
L = 92 dB(A)
pA
3 dB
L = 103 dB(A)
WA
3 dB
, K = 1,5 m/s
2 2
= 3,9 m/s , K = 1,5 m/s
2
, K = 1,5 m/s
2 2
= 9,0 m/s , K = 1,5 m/s
2
WARNING!
► The vibration level varies depending on the
use of the power tool and may be higher
than the value specified in these instructions
in some cases .
Regular use of the power tool in this way may
cause the user to underestimate the vibration .
Try to keep the vibration loads as low as
possible . Measures to reduce the vibration
load are, e .g . wearing gloves and limiting the
working time . Wherein all states of operation
must be included (e .g . times when the power
tool is switched off and times where the
power tool is switched on but running without
load) .
In accordance with DIN EN 60745-1
General Power Tool
Safety Warnings
2
WARNING!
► Read all safety warnings and all instructions .
2
Failure to follow the warnings and instructions
may result in electric shock, fire and/or
serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents .
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .
GB │ IE │ NI │ 3 ■