Adjusting The Shelf; Connection To The Mains Supply - FRIGOGLASS OPM Bedienungsanleitung

iv. Allow a minimum gap of 100mm at the top, 100mm at the rear and 50mm at the sides of the
cooler for proper ventilation. Do not place anything on top of the ICM.

3.2. Adjusting the shelf

To adjust the shelf, you must first unload it. Then, lift
and remove the shelf base plate, and follow the
steps below:
1. lift the shelf support from its back end,
2. tilt slightly forward,
3. pull to remove.
Place at the desired position by repeating the same
steps in reverse order.

3.3. Connection to the mains supply

Connect the ICM to a 220-240 Volt power supply on a min 16A fused & grounded fixed socket. Do not
use extension cables.
Keep the ventilation openings, both in the appliance enclosure and in the
built-in structure, clear of obstruction.
Do not damage the refrigeration circuit.
Do not connect the merchandiser to:
•
a non grounded wall socket or power line
•
improper supply voltage and frequency
•
power supply that does not comply with the safety regulations of the
appliance or with current legislation on electrical installations
•
Do not plug the cooler into a multiple outlet strip or use extension
cables
•
If the supply cord is damaged, it must be replaced with a new one by
the manufacturer, its authorized service provider/agent or similarly
qualified person.
•
Route the power cables in such a way that they are protected from
damage and they do not pose a risk of tripping.
ENG
13