Maximum Weight Per Shelf; Installation & Operation; Installation Instructions - FRIGOGLASS OPM Bedienungsanleitung

ENG

2.5. Maximum weight per shelf

Model
OPM [R290]
OPL [R290]
OPXL [R290]
3. Installation & Operation

3.1. Installation instructions

i. After unpacking, check the cabinet for any damage caused during transportation. In the event of
damage, please contact the forwarding company.
ii. Always ensure that your merchandiser is installed on a stable surface/floor and is properly
leveled. There are 2 or 3 adjustable feet at the front, under the chassis. Please, adjust until the
ICM levels and check using a spirit level, if available.
Mains connection: If the mains cord supplied is not long enough, do not use an extension lead and do
not replace it. Ask an authorized electrician to replace the cord with a longer one.
iii. The merchandiser must stand upright for at least 1 hour after transportation and prior to start-
up. This provides sufficient time for the oil to run back to the compressor after transit and
installation.
12
OPM [R290], OPL [R290] & OPXL [R290] are equipped with HC
refrigerant, and have been tested and proven to be safe
according to related standards.
All necessary actions for safe usage & maintenance of this
appliance are described in this manual. Read carefully before
using the appliance and follow all precautions included in this
manual.
To reduce the possibility of fire, this appliance must be installed
only by a suitably qualified person.
Failure to comply with the instructions may result in high-energy
consumption, poor performance of the unit and void warranty.
Do not place the merchandiser:
•
in direct sunlight or near heat sources (radiators, stoves & other
heating equipment)
•
outdoors
•
in weather conditions for which it is not certified
•
in extreme environmental conditions (i.e. extensive exposure to
saline humidity, areas with potential water accumulation)
•
on a tilted surface angled with an angle bigger than 5
Maximum weight per shelf
39
59
79
o