Adjusting The Shelf (Not Applicable To Units With Plastic Inner Liner); Connection To The Mains Supply; Operation Instructions - FRIGOGLASS Plus-450 R290 C Bedienungsanleitung

ENG
iv. Allow a minimum gap of 100mm at the top, 100mm at the rear and 50mm at the sides of the
cooler for proper ventilation. Do not place anything on top of the cooler.
3.2

Adjusting the shelf (not applicable to units with plastic inner liner)

To adjust the shelf first unload it, lift it and unclip the shelf clips (4). Place the clips in the desired
position and reposition the shelf. Make sure that the horizontal metal rods at the bottom of the shelf
are between the front and back shelf clips.
3.3

Connection to the mains supply

Connect the ICM to a 220-240 Volts power supply on a 10A-16A fused & grounded
socket. Do not use extension cables.
3.4

Operation instructions

3
Do not connect the merchandiser to:

a non grounded wall socket or power line

improper supply voltage and frequency

power supply that does not comply with the safety regulations of
the appliance or with current legislation on electrical installations

Do not plug the cooler into a multiple outlet strip or use
extension cables.

If the supply cord is damaged, it must be replaced by the
manufacturer or authorized service provider.

If the mains cord supplied is not long enough, do not use an
extension lead and do not replace it. Ask an authorized
electrician to replace the cord with a longer one, if such is
described in the list of authorized spare parts only.

Route the power cables in such a way that they are protected
from damage and they do not pose a risk of tripping.
Do not use electrical appliances inside the storage compartments of the
appliance, unless recommended by the manufacturer.