First Aid; Disposal Of The Unit; Recycling Information - FRIGOGLASS OPM Bedienungsanleitung

ENG
FAULT
The ICM sometimes
makes noise.
There is water on the
floor.
The lights don't
work.
If after all the above-mentioned checks the problem with your ICM remains, contact the customer
service department of your supplier and provide the following information:
• Type of ICM
•
Serial number of the ICM
•
Brief description of the problem / observation

8. First Aid

In case of accident, proceed to the following:
ACCIDENT
Inhalation of refrigerant
Contact with eyes
Contact with skin

9. Disposal of the Unit

For detailed information regarding the recycling of this product, please contact your local city office,
your waste disposal service or the manufacturer through its service agent. By ensuring this product is
disposed of properly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise incur by this product's inappropriate disposal.

10. Recycling Information

1. Based on the objectives of environmental policy according to the European Community (EC)
directives of Waste Electrical and Electronic Equipment (WEEE)
*
References
Waste Electrical and Electronic Equipment (WEEE) European Community (EC) Directive Nr. 2002/96/EC
18
POSSIBLE REASONS
Inclined or curved floor.
The drainage hole for the
condensate water is blocked.
There is a leakage in the tray.
The lighting device or ballast or
starter are out of order.
IMMEDIATE ACTION
Take deep breaths of clean air. If irritation persists, contact a
doctor.
Wash your eyes thoroughly with plenty of water for at least 15 minutes
and then consult a doctor
Wash immediately with water.
HANDLING
Level the ICM properly by adjusting its
feet. Placing a spirit level on the top of
the ICM will assist you in leveling it.
Unblock the drainage hole.
Call a Service technician.
Call a Service technician.
* which aim to preserve,