Mounting The Wall Bracket; Assembly; Operation - Silvercrest KH 4421 Bedienungsanleitung

2. Place the charging station 7 next to a power
socket and plug the power adapter in.
The charging station can optionally be moun-
ted on a wall with the supplied screws and
i
plugs (see Chapter „Mounting the wall
bracket"). Vertical screw spacing 102 mm,
screw diameter 3,5 mm. The borehole has to
fit for plug diameter 5 mm.
You can store the crevice tool
upholstery brush
station 7.
3. Place the hand vacuum cleaner in the charging
station 7.The charge indicator light 6 lights up
red and the charging process begins.
Important:
• Once the charging process is completed, the
appliance automatically switches to the charge
maintenance function. However, in order to avo-
id possible damage to the batteries, do not lea-
ve the appliance constantly connected to the
charging station .
• Only place the appliance back on the charging
u
station once the vacuum power becomes
noticeably weaker.
Important information about the
battery
In the event of a defective battery, please contact
our service centre directly. Please refer to the gua-
rantee card for the Authorized Service Outlet in
your country.
and the
in the slots on the charging

Mounting the Wall Bracket

1. Bore two holes with a spacing of ca. 102 mm.
Using the wall bracket 7 to mark the boreholes
ensures the correct spacing.
2. Push the plugs 8 into the boreholes and screw
in the lower screw 8 until ca. 3mm is
protruding.
3. Place the wall bracket 7 on the lower screw.
4. Guide the upper screw 8 through the wall brak-
ket 7 and into the borehole, then screw it in.
5. Tighten both screws 8 down.

Assembly

NOTE:
Make certain that the dust filter 3 is always inser-
ted before using the appliance.
1. To open the dust collector 2, turn the dust
collector 2 and pull it off the motor unit 4.
Make certain that the dust filter 3 is inserted
and put the dust collector 2 back on. Turn the
dust collector 2 until the arrow symbol points to
the dot on the motor unit 4.
2. Should the crevice tool
brush be required, insert them into the
suction opening of the dust collector 2.

Operation

1. Remove the hand vacuum cleaner from the char-
ging station 7. Using the supplied plugs and
screws 8 the charging station 7 can optionally
be mounted on the wall.
2. To switch the appliance on, move the on/off
switch 5 to the position "I".
3. After use place the on/off switch 5 into
position "O".
4. The crevice tool
hard-to-reach areas.
- 4 -
or the upholstery
is used to clean narrow,