Cleaning Advice; Storage; Troubleshooting - Silvercrest SHMM 350 A1 Bedienungsanleitung

WARNING! Risk of material dam-
age!
Do not use any astringent or abrasive
cleaning agents.
All parts except for the hand mixer 6
are dishwasher-safe up to 70 °C.
1. Disconnect the mains plug 5 from the
wall socket.
2. If necessary, wipe down the hand mix-
er 6 (motor unit) and the power ca-
ble 5 with a damp cloth several times.
Ensure no water or moisture gets into
the device and that the hand mixer 6
(motor unit) is completely dry before the
next use.
3. The following accessory parts can be
washed by hand or in the dishwasher:
- the dough hooks 2
- the beaters 3
- the working cover 15
- the jug 16
- the blade assembly 17
- the anti-slip mat 19
4. Let all parts dry completely before you
put them away or use the device again.

Cleaning advice

• Clean the device and all parts as soon
as possible after use in order to prevent
food remnants from drying on.

9. Storage

DANGER for children!
Keep the device out of the reach of chil-
dren.
DANGER!
In order to avoid accidents, the mains
plug 5 must never be connected to a
wall socket while in storage.
• Remove the dough hooks 2 or beat-
ers 3 from the hand mixer 6 for stor-
age.
• Wind the power cable 5 loosely
around the hand mixer 6.
• Assemble the multi chopper for storage
purposes. This allows the blade assem-
bly 17 to be stored safely.
• Select a location where neither high
temperatures nor moisture can affect the
device.

10. Troubleshooting

If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
Do not attempt to repair the device your-
self under any circumstances.
Fault
• Has the device been
• Is the device assem-
No function
• Hand mixer: is the
Dough hooks 2 / Switch off immediately
beaters 3 not and check:
turning or turn- Blockage in the jug?
ing with difficulty. Food too hard?
Dough too tough?
Dough hooks 2 / Right and left dough
beaters 3 can- hook 2 / beater 3 inter-
not be inserted. changed? Observe the
marking ring 1.
Possible causes /
Action
connected to the
power supply?
bled correctly?
cover 13 locked
tightly?
GB
13