Silvercrest SHMM 350 A1 Bedienungsanleitung Seite 8

The device is designed for continuous operation of
... a maximum of 10 minutes in the hand mixer function, or
... a maximum of 60 seconds in the multi chopper function.
After this, the device must remain switched off until it has cooled
down to room temperature.
For the hand mixer function: the device is designed for standard
household quantities. It can process heavy doughs up to max.
500 g flour in one process step (10 minutes).
Switch the device off and pull out the mains plug from the wall
socket before you exchange auxiliary or additional equipment
moving in operation.
DANGER for children
Children must not play with packing ma-
terial. Do not allow children to play with
plastic bags. There is a risk of suffoca-
tion.
Keep the device out of the reach of chil-
dren.
DANGER to and from pets
and livestock
Electrical devices can represent a haz-
ard to pets and livestock. In addition,
animals can also cause damage to the
device. For this reason you should keep
animals away from electrical devices at
all times.
DANGER! Risk of electric
shock due to moisture
The device must never be operated in
the vicinity of a bathtub, a shower, a
filled washbasin or similar.
The hand mixer (motor unit), the power
cable and the mains plug must not be
immersed in water or any other liquids.
Protect the hand mixer (motor unit)
against moisture, water drips and
splashes.
If liquid gets into the device, remove the
mains plug immediately. Have the de-
vice checked before reusing.
6
GB
Never touch the device with wet hands.
If the device falls into water, disconnect
the mains plug immediately. Only then
is it safe to retrieve the device.
Fill the jug with a maximum of 1000 ml
of liquid in order to prevent liquid from
getting into the hand mixer (motor unit).
DANGER! Risk of electric
shock
Only plug the mains plug into the wall
socket after the device has been com-
pletely assembled.
Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
Ensure that the power cable cannot be
damaged by sharp edges or hot points.
Even after it has been switched off, the
device has not been completely discon-
nected from the mains. In order to fully
disconnect it, pull out the mains plug.
When using the device, ensure that the
power cable cannot be trapped or
crushed.
When removing the mains plug from the
wall socket, always pull the plug and
never the cable.