Adding More Ingredients; After You Have Finished Using Your Appliance - Silvercrest SKV 1200 A1 Bedienungsanleitung

WARNING! RISK OF INJURY!
► Ensure that the rotary switch 3 is turned to
"0" before you place the blender t on the
blender drive i . Otherwise the appliance will
start immediately as soon as the blender t
has locked into place .
3) Place the blender t on the blender drive unit
i so that the lock tabs on the underside of
the blender t lock into the recesses on the
blender drive unit i . The
blender t must be pointing to the
on the appliance . Turn the blender t anti­
clockwise as far as it will go . The
on the blender t must then be pointing to the
symbol on the appliance .
4) Add the ingredients .
5) Place the blender lid r with measuring cup e
in position so that the lips of the blender lid r
also seal the spout .
6) Turn the rotary switch 3 to the desired setting .
NOTE
► The ideal speed depends on the consistency
of the items being mixed . The more liquid the
contents are, the faster you can mix them .
► For short, powerful pulsed operation, turn
the rotary switch 3 anticlockwise to level P .
Level P does not lock into place so as not
to overload the motor . You should therefore
keep the rotary switch 3 in this position only
for a short time .
CRUSHING ICE
► In order to produce crushed ice, place ice
cubes in the blender t, close it and turn the
rotary switch 3 approx . 7 times to level P
for 5 seconds . You may need to adapt the
above instructions depending on the quantity
and size of the ice cubes .
SKV 1200 A1

Adding more ingredients

1) Turn the appliance off using the rotary switch 3 .
2) Remove the blender lid r and add the ingredi­
or
3) Turn the measuring cup e in the blender lid r
symbol on the
After you have finished using your
symbol
appliance
1) Turn the appliance off using the rotary switch 3
symbol
2) Turn the blender t clockwise so that the
3) Place the drive protection cover u back on
ents
clockwise as far as it will go and then take it
out . Add the ingredients gradually through the
opening in the blender lid r .
(Position "0") .
symbol on the blender t is pointing to the
symbol on the appliance and remove it .
NOTE
► Ideally, you should clean the blender t im­
mediately after use (see the section "Cleaning
and care") . This makes food residues easier
to remove .
the blender drive i so that the
the drive protection cover u is pointing to the
symbol on the appliance . Turn the drive
protection cover u anticlockwise so that the
symbol on the drive protection cover u is
pointing to the symbol on the appliance .
symbol on
GB │ MT 63 ■
│