Adding More Ingredients; After You Have Finished Using Your Appliance; Cleaning And Care - Silvercrest SKMP 1300 B3 Bedienungsanleitung

CAUTION! PROPERTY DAMAGE!
► Never use the mixing bowl 6 and the
blender t simultaneously! This will overload
the drive!
► When working with the blender t, we
recommend allowing the appliance to cool
down after 3 minutes of operation .
Proceed as follows to prepare the appliance for
operation using the blender t . Refer to figure C
on the back flap .
1) Push the release lever 2 upwards and push
the swivelling arm 1 down into its working
position .
2) Pull off the drive unit lid u .
NOTE
► Ensure that the rotary switch 3 is set to the
"0" position before fitting the blender onto
the drive unit . Otherwise, the appliance will
start automatically as soon as the blender is
locked in .
3) Place the blender t onto the blender drive
unit o so that the locking mechanisms on the
bottom of the blender t fit into the recesses
in the blender drive unit o . The arrow on the
blender t must point to the
the appliance . Rotate the blender t clockwise
as far as it will go . The arrow on the blender t
will then point to the
4) Add the ingredients .
5) Place the blender lid r with measuring cup e
onto the unit, making sure that the lip on the
lid r seals the spout .
6) Turn the rotary switch 3 to the required setting .
SKMP 1300 B3
symbol on
symbol on the appliance .
NOTE
► The optimal speed depends on the consistency
of the food to be processed . More liquid
contents can be blended faster .
► For short, powerful pulses, set the rotary
switch 3 at least to level 1 and simultane-
ously press the PULSE button 4 . The PULSE
button 4 does not lock, in order to avoid
overloading the drive . Therefore, hold the
PULSE button 4 in this position only for a
short period .

Adding more ingredients

1) Switch the appliance off using the rotary
switch 3 .
2) Remove the blender lid r and insert the
ingredients .
or
3) Rotate the measuring cup e situated within the
blender lid r 90° and remove it . Then gradu-
ally add the ingredients using the opening .
After you have finished using your
appliance
1) Switch the appliance off using the rotary
switch 3 .
2) Rotate the blender t anticlockwise until the
arrow on the blender t points to the
symbol on the appliance, then remove it .
NOTE
► Ideally, you should clean the blender t im-
mediately after use (see the section "Cleaning
and care") . This makes food residues easier
to remove .

Cleaning and care

DANGER – ELECTRIC SHOCK!
► Before cleaning the appliance, disconnect
the power plug from the mains power socket!
There is a risk of electric shock!
NEVER immerse the appliance in water or
any other liquid!
│ 25 ■
GB