Pulse Function; Overheating Protection; Dismantling The Device; Cleaning And Servicing The Device - Silvercrest SKMP 1300 C2 Bedienungsanleitung

NOTE: above all, the ideal speed depends
on the consistency of the material being
blended. The more liquid the contents, the
faster you can blend them.

9.3 Pulse function

NOTE: the pulse function only works if the
speed control 11 is set to at least 1.
• By pressing the PULSE 12 button, you
can briefly increase the speed to the
highest setting (10).
• Use the pulse function to shred small
quantities of e.g. nuts, herbs or onions
in the blender jug 5.

9.4 Overheating protection

The device has an overheating protection
system. If the motor becomes too hot, the de-
vice automatically switches itself off:
1. Switch off the device.
2. Pull out the mains plug 13.
3. Allow the device to cool down to room
temperature.
When the device has cooled down suffi-
ciently, it can be switched on again.
10. Dismantling the de-
vice
Removing the blender jug
1. Rotate the blender jug 5 anticlockwise
slightly, and lift it off upwards.
2. Replace the cover 8.
Removing the lid of the blender
jug
3. Rotate the lid 2 anticlockwise until you
can remove it.
4. Rotate the lid of the refill opening 1 anti-
clockwise and remove it.
Lifting up the drive arm
5. Turn the unlocking lever 10 to point up-
wards (in the direction of the arrow)
and lift up the drive arm 22 until it
clicks into place and the unlocking le-
ver 10 snaps back into its locked posi-
tion.
Removing the mixing tool
6. Press the mixing tool upwards slightly
and rotate it clockwise until it can be re-
moved from the axle 23.
Removing the splash guard
7. Rotate the splash guard 21 anticlock-
wise until it can be removed.
Removing the mixing bowl
8. Rotate the mixing bowl 15 anticlock-
wise until it can be removed.
Lowering the drive arm
9. Rotate the unlocking lever 10 upwards
in the direction of the arrow.
10.Move the drive arm 22 all the way
down. The unlocking lever 10 jumps
back to the vertically locked position.
11. Cleaning and servic-
ing the device
DANGER! Risk of electric shock!
Disconnect the mains plug 13 from the
wall socket before each cleaning.
Never immerse the base unit 19 in wa-
ter.
DANGER! Risk of injury from
cutting!
Please remember that the blades 6 of
the blender jug 5 are very sharp. Never
touch the blades 6 with your bare
hands, to avoid cuts.
13
GB