Silvercrest SKMP 1300 C2 Bedienungsanleitung Seite 9

When using the device, ensure that the
power cable cannot be trapped or
crushed.
When removing the mains plug from the
wall socket, always pull the plug and
never the cable.
Disconnect the mains plug from the wall
socket...
... if there is a fault,
... when you are not using the food pro-
cessor,
... prior to assembling or disassembling
the food processor,
... prior to cleaning the food processor
... during thunderstorms.
Do not use the device if there is visible
damage to the device, accessories or
power cable.
To avoid any risk, do not make modifi-
cations to the product.
DANGER! Risk of injury
from cutting
Never reach into the rotating blades. Do
not touch rotating parts with spoons or
similar utensils. Keep long hair or loose
clothing away from rotating parts as
well.
Please remember that the blades contin-
ue to turn for a short time after switching
off the device.
DANGER from rotating
parts
Do not touch rotating parts with spoons
or similar utensils. Keep long hair or
loose clothing away from rotating parts
as well.
Always ensure that the speed control is
set to 0 before you plug the mains plug
into the wall socket.
Switch the device off and pull out the
mains plug from the wall socket before
you exchange auxiliary or additional
equipment moving in operation.
When the blender jug is not attached, the
cover must be mounted. Otherwise the
device will not work, in order to avoid in-
juries.
WARNING! Risk of material
damage
Place the device exclusively on a level,
dry, non-slip and waterproof surface, so
that it can neither fall nor slip off.
The mixing mechanism must not be op-
erated continuously for longer than
10 minutes, or the blender for longer
than 3 minutes. You must then allow the
device to cool down to room tempera-
ture.
The device must never be operated with-
out the jug.
Never place the device on a hot sur-
face, e.g. hot plate.
Do not change the position of the de-
vice, as long as there is still food or
dough in the device.
Never overfill the blender jug or mixing
bowl, since otherwise the contents could
be ejected. Overflowing liquid would
flow onto the surface. You should there-
fore place the device on a waterproof
surface.
Do not operate the device when it is
empty, as this causes the motor to over-
heat and may result in it being dam-
aged.
Never fill the blender jug with hot or
boiling material.
Only use the original accessories.
Do not use any astringent or abrasive
cleaning agents.
The device is equipped with non-slip
plastic suction feet. As furniture is coat-
ed with a wide array of varnishes and
plastics, and is also treated with differ-
ent care products, it cannot be fully
ruled out that some of these materials
contain ingredients that could attack
and soften the non-slip plastic suction
feet. If necessary, place a non-slip mat
under the device.
7
GB