Maintenance And Lubrication; Implements - Grillo G52 Gebrauchs- Und Wartungsanleitung

MAINTENANCE AND LUBRICATION

LUBRICATION: do the following operations with machine in horizontal position.
N.B.: the oil change must be effected with warmed up machine in order to help the total oil drainage.
ENGINE OIL: Follow the instructions on the «Engine operator's manual» carefully. It is however necessary to
handbook).
GEARBOX OIL:
Change oil once per year.
MAINTENANCE:
must be always clean and greased.
To remove the fairing pull upward. The same for the cutter bar conveyor.
Spare parts we recommend to have in stock:
– 1 accelerator cable
– 1 wheel engaging cable
– 1 gas throttle lever
HOW TO ORDER SPARE PARTS: address to your area agent or local dealer in your country. Always give the
machine serial number and part number:
GRILLO S.p.A.
Tel. 0039 - 0547 - 633.111 / Fax 0039 - 0547 - 632.011
Web site: www.grillospa.it / e-mail: grillo@grillospa.it
END OF SEASON MAINTENANCE
Clean the machine carefully.
Change engine and gearbox oil.
Put two wooden boards under the wheels.
I M P L E M E N T S
ROTARY TILLER
Tilling depth can be adjusted by lifting or lowering the central knife situated under the rotary unit. To increase
depth it is necessary to lift the knife. It is advisable to start working with the knife in the lowest position and lift it
when a deeper tillage is requested.
Important
a stone or any other foreign object suddenly block the tiller rotation. Should this happen, you have to stop im-
N.B.: on hard soils the machine may jump forward. If so, lower the central knife to the maximum keep-
8