Vertical Steam Ironing; Refilling With Water - Silvercrest SDBS 2400 B2 Bedienungsanleitung

Vertical steam ironing

♦ Hang the fabric to be ironed on a clothes hanger which is hung against a
heat-resistant surface.
♦ Insert the plug into a mains power socket.
♦ Set the On/Off switch
integrated control lamp in the On/Off switch
lamp
♦ Turn the temperature control
temperature control
♦ The heat-up indicator lamp
temperature has been reached, the heat-up indicator lamp
♦ Adjust the steam power:
–
Press the "MAX" button
–
Press the "ECO" button
♦ As soon as the "MAX"
(depending on the setting), you can start steam ironing.
♦ Hold the steam iron in a vertical position and press the steam button
♦ Touch the fabric lightly with the sole of the iron
creases.
♦ Release the steam button
♦ Put the iron down on the stand
Set the temperature control
♦ Set the On/Off switch
integrated control lamp in the On/Off switch
"MAX"
♦ Pull the plug out of the mains socket.
Refilling with water
You can refill the appliance with water while it is switched on.
♦ Put the iron down on the stand
♦ Refill the water as described in the section "Filling the water tank".
■ 80 │ GB │ MT
to the position "1" to switch the appliance on. The
light up, the "MAX" button
must be set within the
lights up during heating. As soon as the set
to create maximum steam.
to produce less steam.
or "ECO" button
to stop the appliance producing steam.
to the position "0" to switch the appliance off. The
or "ECO" go out.
and the heat-up indicator
flashes.
to set the required ironing temperature. The
range to produce steam.
lights up continuously
and steam it to remove
on the base station
to "min".
and the steam control lamp
on the base station
goes out.
.
after ironing.
.
SDBS 2400 B2