Cleaning The Appliance - Silvercrest SDBS 2400 B2 Bedienungsanleitung

♦ Place the new limescale filter
down until it is firmly in place.
♦ Push the water tank
♦ Set the On/Off switch
♦ Press the "Anti calc" button
You have now completed replacement of the limescale filter
NOTE
► After replacing the limescale filter
starts coming out of the sole of the iron
appliance.
NOTES
Note the following when handling the limescale filter
Not suitable for consumption/drinking!
Keep the limescale filter
Store the spare limescale filter in a cool, dry location.
If the appliance is used regularly, it is advisable to always have a replacement
limescale filter available. This means that you can replace the limescale filter
immediately as soon as the "Anti calc" button
You can order new limescale filters
section Ordering replacement parts).

Cleaning the appliance

♦ Remove the power plug from the mains power socket if the appliance is
plugged in.
♦ If necessary, allow the appliance to cool down before cleaning it.
♦ Clean the surfaces of the iron and the base station
cloth only.
♦ Clean the sole of the iron
the iron
♦ Pour out the residual water in the water tank
–
Pull the water tank
water into the wash basin.
–
Push the water tank
♦ The appliance must be completely dry before further use.
■ 82 │ GB │ MT
in the limescale filter shaft and press it
back into the base station
to the position "1" to switch the appliance on.
. The "Anti calc" button
out of the reach of children.
with a soft, damp cloth. Ensure that the sole of
is not scratched.
out of the base station
back into the base station
until it clicks into place.
, it takes about 90 seconds until steam
again the next time you use the
:
lights up.
from our service department (see
with a soft, damp
:
and tip the remaining
until it clicks into place.
goes out.
.
SDBS 2400 B2