Technical Data; Equipment; Initial Commissioning; Inspection And Operating Instructions - Kerbl constanta3-series Bedienungsanleitung

2.2 Technical data

Type designation:
Supply voltage:
Motor rating:
Frequency:
Dimensions (W/H/L):
Weight without cable:
Sound pressure level:
Strokes:
Protection class:
Safety (for C3-R and C3-P):
CE (for C3-R and C3-P):
Operating conditions
Max. ambient temperature:
Max. air humidity:

2.3 Equipment

1 clipper with clipper head, 1 set of shear blades (mounted), 1 bottle of oil SÄE 30 HD
(100 ml), 1 screwdriver, 1 operating manual and 1 storage case

3. Initial commissioning

3.1 Inspection and operating instructions

The inappropriate use of electrical devices, in particular animal breeding devices, is dange-
rous! Therefore, observe the following, accident prevention measures before starting the
machine.
• Never switch the machine on without properly mounted clipping plates • The volt specifi-
cation on the rating plate must correspond to the mains voltage. The machine may only
be operated with AC • Avoid any contact with the moving blades • Always pull the power
supply plug out prior to maintenance work! Do not touch the blade area, even if the machine
is switched off, as long as the machine is connected to the current supply • Always place
machine on a dry surface and store in dry rooms • Avoid any contact with a machine,
which is in contact with liquids. Never clip wet animals. Liquids that have penetrated into
the machine reduce the electrical insulation. There is the imminent danger of an electric
shock or short-circuit. Only clean the machine with a dry cloth and a paint-brush or brush
• A cable lying on the floor can get caught and be dangerous. Lay the cable carefully and
safely before clipping. Prevent the clipper connection cable from kinking or tangling. Ensure
that animals do not stand on the cable, walk over it or get caught. Keep the cable away
from hot surfaces. Never wind the cable around the machine. This can result in insulation
damage and cable break. Examine the cable regularly for defects • Set the machine switch
to off (fig. 1, pos. 1, position 0) before pulling the plug from the mains • Do not use da-
maged shear blades with broken off teeth.Only use sharp shear blades. Only use the original
shear blades • Never insert an item into an opening of the machine. The machine noise
can disturb animals. A kick or the weight of the animal can result in substantial injuries.
Therefore fixate the animal sufficiently. • Animals should only be clipped, when unauthorised
persons do not have access to the clipping location • Only clip in well-ventilated rooms and
never in the proximity of explosive materials. These safety notes must be observed in all
cases!
Constanta3/R
230 V AC
400 W
50 Hz
7.8 x 9.7 x 33 cm
1490 g
87 dB (A)
2400/ min
II
Corresponds to EN 60335-1, EN 60335-2-8, EN 50366
CE-marking in accordance with the directives
89/336/EEC, 72/23/EEC and 93/68/EEC
0 – 40° C
10 – 90 % (relative)
21
Constanta3/P
230 V AC
120 W
50 Hz
7.8 x 9.7 x 33 cm
1390 g
78 dB (A)
2400/ min
II