General Information; Fundamental Safety Instructions; User Requirements; Intended Purpose - Kerbl 18190 Bedienungsanweisung

1. Safety regulations

1.1 General information

These safety regulations contain fundamental information, which must be observed during installation, operation and
maintenance. All persons working on and with the clipper must read the operating instructions. The operating instruc-
tions must be permanently available at the machine usage site.

1.2 Fundamental safety instructions

Observe the legal regulations on regular examinations.
Also observe the industrial safety regulations.
1.2.1 Power supply
Only insert the plug into correctly installed sockets. Defective electrical installations can cause an electric shock or a
short-circuit. Sockets should be equipped with an earth leakage circuit breaker (FI). Observe your local pertinent regulati-
ons. Only carry out maintenance and cleaning tasks after pulling the plug. Never leave the machine unsupervised when
plugged in. Clipping animals is only permissible, if children are kept away from the clipping location. Do not store your
machine in reach of children!
1.2.2 Maintenance and service obligation
Never use a damaged machine for clipping. Only allow authorised technical personnel to repair the housing or defective
electrical cable.
1.2.3 Radiation
The clipper examination complies with the fundamental protection requirements according to the harmonised European
standards of the EEC Directive. EU Directive: 2004/108/EG
1.2.4 Remaining risks
Please notify us of operational dangers and risks, which do not occur when directly trimming the animals. This also
applies to endangering technical defects.

1.3 User requirements

Observe and comply with the instructions in this manual to ensure safe use of the clipper.
• The user has read and understood the operating instructions or an expert has explained the operation and pointed out
the risks. • The user is experienced in clipping animals. Children and frail persons (without supervision) should not use
the clipper.
2. Designated use

2.1 Intended purpose

The clipper is exclusively intended for clipping sheep or llamas. Any other use, in particular on humans, is explicitly
prohibited.

2.2 Technical data

Type designation: 18190
Supply voltage: 230 V AC
Motor rating: 200 W
Frequency: 50 Hz
Dimensions (W/H/L): 6 x 9 x 33 cm
Weight without cable: 1200 kg
Sound pressure level: 85 dB (A)
2.3 Equipment
1 clipper with clipper head, 1 set of shear blades (mounted), 1 screwdriver, 1 operating manual and 1 storage case
Strokes: 2600/ min
Protection class: II
Safety: Corresponds to EN 60335-1, EN 60335-2-8, EN 62233
CE: CE-marking in accordance with the directives
2004/108/EG, 2006/95/EG
Operating conditions
Max. ambient temperature: 0 – 40° C
Max. air humidity: 10 – 90 % (relative)
15