Technical Data; Assembly - Kerbl RotaBrush Classic Bedienungsanweisung

Technical data:

No. motors
Voltage supply
Frequency
Capacity
Consumption
Overall weight
Brush dimensions
Brush movement speed
Assembly instructions:
RotaBrush Classic and Twin are supplied completely assembled and ready for installation (See fig.).
The oscillating brush is supplied with the machine body completely assembled and ready for
installation, except for the assembly of:
• roller, which must be inserted on the roller shaft
• support bracket which must be fastened to the wall for hooking the brush support.
• electric cable to be positioned and fastened inside the clips already on the support arm
(Attention to instructions in Fig.5)
To assemble the roller, remove the nut and washer which, after inserting the roller on the shaft, must be screwed
and tightened again on the shaft. The roller can be inserted in either direction.
Assembly instructions are given in figures 3-4-5-6.
Abb. 1 – RotaBrush Classic: assembling
Classic
1
220V – 110V
50 – 60 Hz
0.5 Cv
0.37 kw/h
75 kg
50 x 100
50 rev/min
Swing
1
220V – 110V
50 – 60 Hz
0.5 Cv
0.37 kw/h
80 kg
50 x 100
50 rev/min
Abb. 1 – RotaBrush Twin: assembling and fixing detail
Abb. 2 – CowCleaner Swing : with particular plate for wall mounting
23
Classic
2
220V – 110V
50 – 60 Hz
2 x 0.5 Cv
2 x 0.37 kw/h
130 kg
130 x 138 cm
50 rev/min