Taking Your Blood Pressure Reading; Displaying Stored Results - Gima 32918 Gebrauchsanweisung

27

6. taking your blood pressure reading

a. after applying the cuff and your body is in a
comfortable position, press the "start" button. a
beep is heard and all display characters are
shown for self-test. see picture 6.
please contact the service center if segment is
missing.
b. then the current memory bank (u1 or u2)
is blinking. see picture 6-1. press "mem" button
picture 6
to other bank. see picture 6-2. Confirm your
selection by pressing "start" button. the current
bank can also be confirmed automatically after 5
seconds with no operation. c. after selecting the
memory bank, the monitor starts to seek zero
pressure. see picture 6-3.
d. the monitor inflates the cuff until sufficient
pressure has built up for a measurement.
3
then the monitor slowly releases air from the cuff and carries out the
measurement. finally the blood pressure and pulse
rate will be calculated and displayed on the lCd
screen separately. Irregular heartbeat symbol (if
any) will blink. see picture 6-4&6-5.
the result will be automatically stored in the
current memory
bank.
e. after measurement, the monitor will turn off
automatically after 1 minute of no operation. alternatively, you can press the
"start" button to turn off the monitor manually.
f. during measurement, you can press the "start" button to turn off the
monitor manually.
Note: please consult a health care professional for interpretation of pressure
measurements.

7. displaying stored results

a. after the measurement, you can
review the measurements in the current memory
bank by pressing button "mem". now the lCd
displays the amount of the results in the current
bank. see picture
7.
to change over
picture 6-1
ENGLISH
picture 6-2
picture 6-4
picture 7
picture 6-
picture 6-5
picture 7-1