7 Maintenance
Maintenance
Accessories
Troubleshooting instruc-
tions
74
Addressing PROFIBUS-PA
Open the cover to the DIP switches on the head transmitter. Using a pointed object (small screwdri-
ver) set the position of the mini switches to the required address. Once this has been done close the
cover to the DIP switches..
Fig. 6.1: Addressing using the DIP switches
7
Maintenance
The head transmitter is maintenance-free.
8
Accessories
PC software COMMUWIN II, Proficard or Profiboard, Segment coupler.
Please contact your local supplier when ordering (e.g. accessories and spare parts)!
When ordering accessories or spare parts, please state the serial number of the head transmitter!
9
Troubleshooting
9.1
Troubleshooting instructions
If faults occur after commissioning or during measurement, always start any troubleshooting
sequence using the following check. The user is led towards the possible fault cause and its rectifi-
cation via question and answer.
®
using the DIP switch (optional, s. fig. 6.1)
TMT184
Endress+Hauser