Enabling Or Disabling The System To Record Thermal Alert Logs; Enabling Or Disabling The Configuration Change Detection; Changing The Bios Settings Before Installing A New Operating System - Lenovo ThinkStation P320 Hardwarebedienungsanleitung

4. Select Better Acoustic Performance or Better Thermal Performance as desired and press Enter.
5. To save settings and exit the Setup Utility program, press F10, select Yes in the window displayed,
and press Enter.
Note: For some keyboards, you might need to press Fn+F10 to exit the Setup Utility program.

Enabling or disabling the system to record thermal alert logs

When the ICE thermal alert feature is enabled, if a critical thermal situation occurs, an alert log is written into
the Windows system log. The alert log can help you identify thermal problems, such as malfunctioning fans,
abnormally high temperature, or poor cooling performances.
To enable or disable the system to record thermal alert logs, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 61.
2. Select Power ➙ Intelligent Cooling Engine (ICE) and press Enter.
3. Select ICE Thermal Alert and press Enter.
4. Select the desired setting and press Enter.
5. To save settings and exit the Setup Utility program, press F10 or Fn+F10 (depending on the keyboard).
Then, select Yes in the window displayed, and press Enter.

Enabling or disabling the configuration change detection

With the configuration-change detection enabled, if the POST detects configuration changes of some
hardware devices (such as storage drives or memory modules), an error message is displayed.
To enable or disable the configuration change detection, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 61.
2. Select Security ➙ Configuration Change Detection and press Enter.
3. Select the desired setting and press Enter.
4. To save settings and exit the Setup Utility program, press F10 or Fn+F10 (depending on the keyboard).
Then, select Yes in the window displayed, and press Enter.
To bypass the error message and log in to the operating system, do one of the following:
• Press F2 or Fn+F2 (depending on the keyboard).
• Start and then exit the Setup Utility program. See "Starting the Setup Utility program" on page 61 and
"Exiting the Setup Utility program" on page 66.

Changing the BIOS settings before installing a new operating system

BIOS settings vary by operating system. Change the BIOS settings before installing a new operating system.
To change the BIOS settings, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 61.
2. From the main interface, select Exit ➙ OS Optimized Default and press Enter.
3. Depending on the operating system to be installed, do one of the following:
• To install the Windows 10 (64-bit) operating system, select Enabled and press Enter.
• To install an operating system other than Windows 10 (64-bit), select Disabled and press Enter.
4. Select Yes in the window displayed and press Enter to confirm your selection.
.
Chapter 6 Advanced configuration
63