Cover Presence Switch - Lenovo ThinkStation P320 Hardwarebedienungsanleitung

7. Insert the cable of the new thermal sensor into the lower hole
tabs on the plastic holder holding the thermal sensor with the two holes
push the plastic holder until it snaps into position.
Figure 96. Installing the thermal sensor
8. Connect the thermal sensor cable to the thermal sensor connector on the system board. See "Parts on
the system board" on page 34.
9. Reinstall the front bezel. See "Front bezel" on page 92.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 166.

Cover presence switch

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the cover presence switch, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 91.
2. Locate the cover presence switch. See "Major FRUs and CRUs" on page 31.
3. Disconnect the cover presence switch cable from the cover presence switch connector on the system
board. See "Parts on the system board" on page 34.
1 in the chassis. Then align the two
1 and
.
Chapter 9 Hardware installation and replacement
2 in the chassis, and
139