Front Fan Assembly - Lenovo ThinkStation P320 Hardwarebedienungsanleitung

9. Install the storage converter with the bracket into the storage drive bay. See "Primary hard disk drive" on
page 148 or "Secondary hard disk drive" on page 149.
10. Connect the signal cable and the power cable to the solid-state drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 166.

Front fan assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Note: The front fan assembly is only available on some models.
To replace the front fan assembly, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 91.
2. Remove the front bezel. See "Front bezel" on page 92.
3. Disconnect the front fan assembly cable from the power fan connector on the system board. See
"Parts on the system board" on page 34.
4. The front fan assembly is attached to the chassis by four rubber mounts. Remove the front fan assembly
by breaking or cutting the rubber mounts and gently pulling the front fan assembly out of the chassis.
Note: The new front fan assembly comes with four new rubber mounts attached.
Figure 119. Removing the front fan assembly
5. Install the new front fan assembly by aligning the new rubber mounts with the corresponding holes in
the chassis and push the rubber mounts through the holes.
.
Chapter 9 Hardware installation and replacement
155