Rear Fan Assembly - Lenovo ThinkStation P320 Hardwarebedienungsanleitung

6. Pull the tips of the rubber mounts until the front fan assembly is secured in place.
Figure 120. Installing the front fan assembly
7. Connect the front fan assembly cable to the power fan connector on the system board.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 166.

Rear fan assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the rear fan assembly, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 91.
2. Locate the rear fan assembly. See "Computer components" on page 31.
3. Disconnect the rear fan assembly cable from the system fan connector on the system board. See
"Parts on the system board" on page 34.
156
P320 Hardware Maintenance Manual