Front Audio And Usb Assembly - Lenovo ThinkStation P320 Hardwarebedienungsanleitung

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 166.

Front audio and USB assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the front audio and USB assembly, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 91.
2. Remove the front bezel. See "Front bezel" on page 92.
3. Locate the front audio and USB assembly. See "Computer components" on page 31.
4. Note the cable routing and connection. Then, disconnect the front audio and USB assembly cables
from the system board. See "Parts on the system board" on page 34.
5. Remove the screw that secures the front audio and USB assembly. Slide the front audio and USB
assembly to the right as shown to remove it from the chassis.
Figure 91. Removing the front audio and USB assembly
6. Route the cables of the new front audio and USB assembly through the corresponding square hole in
the front of the chassis. Then position the new front audio and USB assembly into the chassis and slide
it to the left as shown. Install the screw to secure the new front audio and USB assembly in place.
Figure 92. Installing the front audio and USB assembly
.
Chapter 9 Hardware installation and replacement
135