Lenovo ThinkStation P320 Hardwarebedienungsanleitung Seite 173

3. Connect the front and rear antenna cables to the Wi-Fi card module.
Figure 136. Installing the Wi-Fi antenna cables
Wi-Fi adapter card
To install the Wi-Fi adapter card, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 91.
2. Install the Wi-Fi adapter card into the PCIe x1 card slot on the system board. See "Parts on the
system board" on page 34.
3. If the installed Wi-Fi card module supports the Bluetooth function, connect a Bluetooth cable from the
Bluetooth connector on the Wi-Fi adapter card to the USB 2.0 connector on the system board.
4. Pivot the card latch to the closed position to secure the Wi-Fi adapter card.
Figure 137. Installing the Wi-Fi adapter card
Rear Wi-Fi antenna
To install the rear Wi-Fi antenna, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
.
Chapter 9 Hardware installation and replacement
165