Lenovo ThinkStation P320 Hardwarebedienungsanleitung Seite 102

6. Remove the two screws that secure the card reader. Then carefully pull out the card reader from
the rear of the front audio and USB assembly.
Figure 13. Removing the card reader
7. Install the new card reader into the card reader slot from the rear of the front audio and USB assembly.
Then install the two screws to secure the card reader.
Note: Carefully handle the card reader by its edges.
Figure 14. Installing the new card reader
8. Install the front audio and USB assembly into the chassis. See "Front audio and USB assembly" on
page 135.
9. Connect the card reader cable to a USB 2.0 connector on the system board. See "Parts on the
system board" on page 34.
10. Reinstall the front bezel. See "Front bezel" on page 92.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 166.
94
P320 Hardware Maintenance Manual