Power Supply Assembly - Lenovo ThinkStation P320 Hardwarebedienungsanleitung

4. Remove the screw that secures the cover presence switch and remove the cover presence switch
from the chassis.
Figure 97. Removing the cover presence switch
5. Position the new cover presence switch so that the screw hole in the cover presence switch is aligned
with the corresponding hole in the chassis. Then install the screw to secure the cover presence
switch to the chassis.
Figure 98. Installing the cover presence switch
6. Connect the cover presence switch cable to the cover presence switch connector on the system board.
See "Parts on the system board" on page 34.
7. Reinstall the front bezel. See "Front bezel" on page 92.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 166.

Power supply assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
140
P320 Hardware Maintenance Manual